Home Products Customers Downloads Accessories Price/Order
    Manufacturers of Industrial Embedded Single-Board Computers for worldwide applications
   Specializing in Custom Design  -  Offering a large selection of  Single-Board Computers
   
  MPS Opto Racks
 

     

Picture of an Opto Rack for a Single-Board Computer

 

 #1046  MPS-08, 8 position
       
   

Opto-isolated modules are used for any of the following reasons:
bulletPrevent noise problems due to ground loops.  Voltage differences between grounding points within a
facility cause unwanted current to flow.  Using opto-isolated modules prevents ground current from
flowing.
bulletEliminate direct connection from one system to another
bulletExtend logic I/O to 240V AC or VDC

 
     

 

 #1047  MPS-16, 16 position
    The MPS series have a footprint that is 29-44 percent smaller than standard opto racks.  The MPS-08, -16, and -25 racks hold 8, 16, and 24 G4 or G5 modules.  G4 modules can switch up to 240V DC or AC at 3A or sense voltages from 3 to 240V.  BASIC commands control or read these modules directly.  The MPS racks interface with the RPC card's digital I/O port using a CMA-26 ribbon cable.  All unused lines from the digital port go to screw terminals, as in the STB-26. 
     

 

 

 #1048  MPS-24, 24 position
    Ordering Information
#1046  MPS-08, 8 position
#1047  MPS-16, 16 position
#1048  MPS-24, 24 position

back
     

 
   
    Remote Processing Corporation
 7975-B East Harvard Avenue, Denver, CO 80231 
 
Phone 303-750-8587
Fax 303-690-1875
     
    [Home] [Single-board Computers] [Customers] [Downloads] [Accessories] [Price/Ordering] [Your Privacy]